General Mechanical

General Mechanical

Regarding implementation of orthotropic plasticity hardening model

    • shubhamiiserk
      Subscriber

      I have been using a workbench additive to simulate my SLM problem. In my simulation, I need to implement an orthotopic plasticity model with yields strengths in x y z directions.

       I searched different models on the internet but I couldn't figure it out. Could you guys please help me implement the plasticity model? Can anyone share some documents which can help me add a model or write an APDL command for the same? 


      Regards

      Shubham Chaudhry

    • Ashish Khemka
      Ansys Employee


      Please see if the following link helps you:

      Modelling orthotropic plasticity material behaviour in Ansys Workbench ÔÇö Ansys Learning Forum

      Regards Ashish Khemka
    • shubhamiiserk
      Subscriber
      Hello akhemka
      Thank you for the information. But, I have seen this post and it didn't help me. I have stress strengths only in x, y, and z, directions. I don't have share stress. Could please provide me with more information?

      Regards
      Shubham Chaudhry
Viewing 2 reply threads
  • You must be logged in to reply to this topic.