Regarding Pressure drop

    • Shubham Dalvi

      Hello Everyone, I am very new to Ansys and working on a simulation for which I just know the mass flow rate at the inlet and the temperature at which the fluid enters. I want to see how the fluid distributes in my domain if I predefine a pressure drop of 4000Pa. Any suggestions on how I can achieve this? 


    • Rob
      Ansys Employee

      Have a look at the tutorials for Fluent. We can either set a pressure drop, or a fixed mass flow through a domain. The latter tends to be more stable. So, if you want to model a 4 kPa pressure drop you can do that, or you can fix the mass flow and measure the pressure change. 

Viewing 1 reply thread
  • You must be logged in to reply to this topic.