July 25, 2019 at 10:24 amsandeepruchi93Subscriber
I'm using ANSYS 15.0. During run calculation, it's showing only No. of iterations (I have attached the image). But I want to set time step sizes and total time, but it is not showing. How we can obtain that page (I have attached the image)
July 25, 2019 at 10:35 am
July 25, 2019 at 10:35 ampeteroznewmanSubscriber
Change the model from Steady State to Transient.
July 25, 2019 at 10:51 amsandeepruchi93Subscriber
Thanks a lot. I had forgotten to change the model. Thanks a lot for your quick reply
- You must be logged in to reply to this topic.
Earth Rescue – An Ansys Online Series
- Saving & sharing of Working project files in .wbpz format
- An Unknown error occurred during solution. Check the Solver Output…..
- Understanding Force Convergence Solution Output
- Solver Pivot Warning in Beam Element Model
- Colors and Mesh Display
- How to calculate the residual stress on a coating by Vickers indentation?
- whether have the difference between using contact and target bodies
- What is the difference between bonded contact region and fixed joint
- The solver engine was unable to converge on a solution for the nonlinear problem as constrained.
- User manual
© 2023 Copyright ANSYS, Inc. All rights reserved.