General Mechanical

General Mechanical

Sent : how to use pressure on balloon for stent simulation

    • aqibdrmc
      Subscriber

      Hi everyone,

      I am totally new to ansys software packages. I am trying to simulate a stent's expansion with a balloon catheter. with help of tutorials I was able to simulate a stent's expansion and balloon's expansion and reduction with displacement.

      However, when I am trying to use pressure instead of displacement, I am not getting any results. I think I do not understand the boundary conditions required for pressure. 

    • peteroznewman
      Subscriber

      Apply the pressure load to the inside diameter face of the stent only.

Viewing 1 reply thread
  • You must be logged in to reply to this topic.