Setting up Dynamic Meshing in a 3 phase system

    • harshabharadwaj1


      Hope you guys are doing well. I have a three phase system with oil, plastic and oil and I wanted to use dynamic meshing since the region between oil and plastic is of vital importance to me and I have to maintain good volume conservation of the oil droplet.

      I am using Sphere of Influence method for meshing and not only is it taking too long, there is still not good enough volume conservation. The volume of the oil starts out at 1 and ends up at 0.8 approx after a while.

    • RK
      Ansys Employee
      Hello, nCan you initialize the solution and then check for the VOF option? n
Viewing 1 reply thread
  • You must be logged in to reply to this topic.