Ansys Products

Ansys Products

Discuss installation & licensing of our Ansys Teaching and Research products

Simulation PMSM at no load condition at SIMPLORER

    • Atefe5131060

      Hello everyone,
      I designed a PMSM at Ansys Maxwell and simulation results at Maxwell are acceptable. I tried to simulate the desired motor at SIMPLORER at no load condition, as shown in the picture. but the motor results are not acceptable (Torque almost zero) and it gives an acceptable answer only if  I connect the V-ROTB (with desired speed as V-ROTB value) to the Motion setup_in.
      Shouldn't the motor be fed with the desired frequency in no-load conditions?

    • GLUO
      Ansys Employee


      Zero should be connected to MotionSetup1_Out, and the speed should be connected to MotionSetup1_In.

Viewing 1 reply thread
  • You must be logged in to reply to this topic.