Preprocessing

Preprocessing

Spaceclaim split volume

    • sidphutane09
      Subscriber

      Hello everyone

      I am new to spaceclaim and fluent i am working on centrifugal compressor so at intial i extract volume from inlet to outlet.

      But right now i want to split that one volue to 3 volume that is inlet rotating body and volute in that way i tried to split by creating surface but after ansys fluent my flow is not to rotating volume it stuck in inlet volume itself please guide me coz i am struggling i lot

    • peteroznewman
      Subscriber
      See if these videos help.
Viewing 1 reply thread
  • You must be logged in to reply to this topic.