3D Design

3D Design

The Physics Definition has been corrupted – Discovery AIM

    • WitMen
      Subscriber

      Hello,

      I am current running a transient Fluid-Dynamics analysis (Discovery AIM 2020 R1). The case is calculated for a while, but suddenly some error messages are displayed and the simulation is stopped

    • Naresh Patre
      Ansys Employee
      HelloWitMennWere there any messages before you clicked the solve physics button? If yes, can you fix them before proceeding to solve the physics?nSecondly, can you click on the more text located near the message Physics region 1 requires attention and check the details? Can you share snapshot of these details?n
    • WitMen
      Subscriber
      Hello nmpatre,nnThere were no messages before I clicked the solve physics button. If I click on the more text, no new information is shown, only that the physics region 1 needs to be re-created, as already told.nIt is strange that the simulation starts and run for a few iterations without any warnings, and then suddenly all the messages are shown together and the simulation stops with the errornnThank you,nn
    • WitMen
      Subscriber
      Just for clarification,nnApparently, the problem has been solved. Just free up Hard disk space and the issue should not happen.nnThank you,n
Viewing 3 reply threads
  • You must be logged in to reply to this topic.