LS Dyna

LS Dyna

Transient structural sampling frequency

    • foXSers
      Subscriber
      I Use Ansys 2020 R1nHello guru.nI am testing an ER16-K bearing with a defect on outer race, use a Machinery Fault Simulator Magnum. My sampling frequency = 20 khz.nNow I have simulated Ansys transient structural and I need to set the sampling frequency to 20 khz.nnMy question is how to do this?nAnd what other solution do I need to set up for data for BPFO, as I understand it Directional Acceleration?nThx so much n
    • peteroznewman
      Subscriber
      Under Step Controls, set the Maximum Time Step to 0.00005 s to have a 20 kHz sampling frequency.nYou posted in Explicit Dynamics area, but mentioned Transient Structural, which is the implicit solver.n
Viewing 1 reply thread
  • You must be logged in to reply to this topic.