General Mechanical

General Mechanical

Unable to perform Mesh convergence analysis

    • dbt2dariomn
      Subscriber

      Hi all,

      I am trying to perform mesh convergece of a bracket. It is computed by using Shell elements, but then when I am trying to solve for the refinement I get the following message:

      The geometry of the bracket is as follows:

       

      Regards

    • peteroznewman
      Subscriber

      Open the Geometry in SpaceClaim and on the Workbench tab, click the Share button. That will cause the mesh to be connected in Meshing without using mesh connections or pinch controls.

Viewing 1 reply thread
  • You must be logged in to reply to this topic.