Ansys Products

Ansys Products

Unable to start the Meshing editor – Ansys2021R1, Linux, VNC, VGL

    • db_ik
      Subscriber

      Ansys 2021R1 - Workbench failed to launch the meshing editor.

      It runs under Linux (RHEL 7.5), VNC connection, virtural GL (2.6.5).

      Please see the attached file for the error message and bash setup.

    • Matt Madore
      Ansys Employee
      Commented through https://forum.ansys.com/discussion/24571/unable-to-start-the-meshing-editor-linux-rhel-7-5-vnc-virtualgln
Viewing 1 reply thread
  • You must be logged in to reply to this topic.