Learning Forum

[mahimaalekh]

sir namaste
I am using ANSYS fluent19R3 for simulating the hydrodynamic behaviour of three phase fluidized bed in 2D. I have defined all the model as eulerian, phases, materials, boundary conditions, patching, and initialization. I have defined liquid as primary phase, air and solids(granular) as secondary phase. while analyzing the results i am not getting the volume fraction contour for secondary phase-air. where as i am getting the contour diagram for liquid and solid.
Please suggest necessary solution for the above said problem
thanking you

[System]

This discussion was created from comments split from: Boundary condition for E-E multiphase model.

[DrAmine]

can you please screenshot the phase variables category and paste it here. The easiest workaround if there is a real issue is to create a Custom Field Function with 1-vf(primary)-vf(solids) for the air phase.

[mahimaalekh]

i defined the model as eulerian and no of eulerian phases-3. I am running the simulation but i am not getting the volume fraction contour for phase-2 and for others i am getting.